Storing Setups - Telos Zephyr User Manual

0:00 |Xmt:L3 Dual
0:00 |56 kbps 32kHz
Ultimately, the resting status screen will come on, as always, after successful dialing:
00:01|Xmt:L3 Dual
00:01|56kbps 32kHz
Note that with a unit properly pre- programmed, it is possible to get a Zephyr on the air
with just two presses of the <AUTO DIAL> button; one to get the menu, and the second
to go.

Storing Setups

Here we offer only an introduction to storing setups. Step- by- step instructions are
included in section 8 (Detailed Menu Reference).
Store setup
Category
>
<+/-> change
This screen, part of the UTILITY menu, allows you to store setups for later use by the
autodial feature. Stored setups include a name for reference, one or two telephone
numbers, and all necessary operating mode values.
Only the setup name, and telephone numbers are required to be entered – all of the
mode information (Xmt, Rcv, and rates) is taken from the system state at the time the
name text is entered. So, make certain that the values you desire are in the system before
storing from this screen.
When the brackets surround the Category menu item mode, the <+/- > keys select
which of the three values is to be entered. The information to be entered is done so on
the third line. Therefore, you will be selecting each Category and then using the <SEL>
button to get to the third line, you will enter the information and store it, and then will
to back to Category and select the next Category. When you are happy with each
BASIC OP
|Rcv:L3 Stereo
|ISDN
|Rcv:L3 Stereo
|ISDN
[ 1 ]
NAME
<
HOT TIP!
A good idea is to test the setup parameters by actually dialing
and confirming that everything works before doing the store
setup operation.
Section 4 INSTALLATION &
75