Telos Zephyr User Manual page 128

Unlike in the LII/III modes, mono audio appears only on the output which
corresponds to the incoming digital channel/line.
•
L2
Receives when the remote transmitter is set to any of the following Layer II modes:
ª
•
•
•
When the source encoder is in LII MONO mode, the mono audio appears on both
output channels.
•
L2 HALF/24 Layer II Single channel special half sample rate (24kHz).
Receives when the remote transmitter is set to the following Layer II mode:
•
This mode will also receive L2 Mono at 48kHz.
128
Section 8
L2 MONO
L2 MONO128
L2 DUAL
L2 JSTEREO
COMPATIBILITY TIP!
The L2 receive mode uses the CDQ method of multiplexing
the two transmission channels to a single bit stream when
transmissions are in the L2 MONO128 and L2 JSTEREO
modes. This method is compatible with other Zephyrs and a
majority of Layer II-only codecs. See the Compatibility Section
of the Appendix for more details.
L2HALF/24
COMPATIBILITY TIP!
Zephyr's monaural Layer II implementation prior to version
2.69 does not include the L2 HALF/24 Xmt and Rcv modes. If
this mode is required contact Telos Systems customer support
for upgrade information.
COMPATIBILITY TIP!
Older Zephyr hardware versions may not support Layer II or
the 48kHz sample rate. If this is the case, Zephyr will display
"Hardware Not Available" if these modes are selected. Contact
Telos Systems customer support for information on upgrades
should these modes be required.
DETAILED MENU REFERENCE