Telos Zephyr User Manual page 166

If there already is a password set:
passwd oldpassword newpassword changes to a new password.
passwd oldpassword * deletes the current password.
Default: no password
reset
Reset Zephyr (warm boot).
A warm boot does not cause deletion of important system information (type of ISDN,
SPIDs, setups etc.).
rxmode <L3MO|L3ST|G722|L2>
Select receive mode (L3- Mono, L3- Stereo, G.722, Layer 2).
Default: L3ST
setup [<1..50>[<-|name <num1|-><num2|-><XmtMode><RcvMode><Rate>]]
Display or define setup. Parameters are: setup number, setup name, two phone
numbers, transmit mode, receive mode, bitrate. See 'txmode', 'rxmode' and 'bitrate'
command for parameters. Enter setup alone to get a list of setups.
Default: all setups are empty
spids <spid1|-> <spid2|->
Enter or delete ISDN SPID numbers.
Default: none
Example:
spids -- will delete all stored SPIDs.
166
Section 9
IMPORTANT!
The "name" must not contain any spaces because space is
the delimiter to the following phone number. To get spaces,
use underscores instead.
HOT TIP!
Setups do not need to have phone numbers associated with
them. A setup without phone numbers can be activated and it
will bring the Zephyr to the selected transmit and receive mode
and bitrate.
REMOTE CONTROL