Table of Contents
Advertisement
GAINING ACCESS
The installation and servicing instructions in this manual are for use by
qualified personnel only. To avoi d electric shock do not perform any ser-
vicing other than that contained in the Operating Instructions unles s you
are qualified to do so. Refer all servicing to qualified service personnel.
CAUTION: As with most switching power supplies the Zephyr's power supply has lethal
voltages, even on parts which might look safe at casual glance. DO NOT TOUCH ANY
PORTION OF THE POWER SUPPLY without removing power cord first.
Removal of the top plate is the first step to gaining access for service. Remove the ten
Philips head screws.
Motherboard Removal
CAUTION
REALLY IMPORTANT NOTE!!
In the case where it is necessary to remove the motherboard,
remove the two screws which mount each of the cards to the
rear panel, remove the retainer screws on the lower DB
connectors, remove the *4* screws which hold the board
down (There is one hiding at the rear end of P2!), and then
release the XLR connectors according to the instructions
below. Disconnect all cables, and away you go.
Section 11
TECHNICAL INFORMATION
203
Advertisement
Table of Contents
Need help?
Do you have a question about the Zephyr and is the answer not in the manual?
Questions and answers