Telos Zephyr User Manual page 167

stat
Get system information.
This command prints a list of the current settings:
>>stat
DSP cards............: 2
Transmitter mode.....: Stereo
Receiver mode........: Stereo
Line bitrate.........: 64 kbps
Network..............: ISDN
Switch type..........: Natl I-1
SPID 1 & 2...........: 21678193100111 21678193110111
Directory numbers....:
Auto answer mode.....: ON
Loopback mode........: OFF
Ancill. data from....: Port 1
Analog input level...: +0 dBu
Last boot mode.......: warm
Autoboot mode........: ON
Panic dial...........: None
Info logging.........: System ISDN extendedISDN
Line status 1 & 2....: Ready Ready
Decoder status.......: unsynced
Encoder status.......: synced
statout <rcv|1|2|1&2|1or2>
Select activation mode for the parallel port STATUS output bit: on receiver lock, on line
1 connected, line 2 connected, both or either line connected.
When followed by a lock mode parameter, this command changes how the STATUS
OUT parallel output is determined, as follows:
Output active when decoder is locked.
rcv
Output active when ISDN line 1 is connected.
1
Output active when ISDN line 2 is connected.
2
Output active when either ISDN is connected.
1or2
Output active when both ISDN lines are connected.
&
1 2
Section 9 REMOTE CONTROL
167