Do A Check On The Cabinet; Replace The Air Inlet Filter - ABB Terra 94 User Manual

Procedure
1. Rinse with low-pressure tap water to remove rough dirt.
2. Apply a a solution of cleaning agent to the cabinet and let it soak.
3. Manually remove dirt. Use the non-abrasive tool.
4. Rinse with low-pressure tap water.
5. If necessary, apply wax on the front for extra protection and gloss.
6. If there was rust and you want it not to appear again, apply a rust-preventive primer.
Ask the manufacturer for specifications and instructions.
4.8.3

Do a check on the cabinet

1. Do a check for damage on these parts:
2. If you see damage, contact the manufacturer. Refer to section
4.8.4

Replace the air inlet filter

Preliminary requirements
BCM.S1101.0-EN | 001
Note: When the EVSE is put in a corrosion sensitive environment, superficial
rust is possible on welding points. This rust is only visual. There is no risk for
the integrity of the cabinet. The procedure below removes the rust.
Caution: Do not use abrasive tools.
Part
EV charge cables and connectors
Touchscreen
Coating of the cabinet
Cabinet
• Spanner
Damage
Cracks or ruptures
Internal wires of the cable are visible
Cracks
Touch screen does not work
Cracks or ruptures
Signs of rust that cause ingress of water
1.12
.
• Air inlet filters. Refer to
section 7.4 .
Operation
27