Operation; Prepare Before Use; Stop The Evse If There Is An Emergency; Reset The Evse After An Emergency - ABB Terra 94 User Manual

Operation

4 Operation
4.1

Prepare before use

1. Appoint a site operator and an installation engineer, if these are other persons than
you.
2. Make sure that the EVSE is installed according to the instructions in the installation
manual.
3. Make an emergency plan that instructs people what to do in case of an emergency.
4. Give these instructions to each end user:
•
•
5. Make sure that the manufacturer commissions the EVSE. Contact the manufacturer
when the EVSE is ready for commissioning. Refer to section
6. Make sure that the space around the EVSE cannot get blocked. Think of snow or
other objects. Refer to the floor space requirements. Refer to section .
7. Make sure that maintenance is done on the EVSE. Refer to section
8. If the EVSE is de-energized for more than two hours, activate the internal heater to
remove condensation from the cabinet. Refer to section
4.2

Stop the EVSE if there is an emergency

1. If there is an emergency, push the
•
•
2. Do not start the EVSE until the situation is safe.
4.3

Reset the EVSE after an emergency

1. Make sure that the situation is safe again.
2. Turn the emergency button clockwise to release it.
•
•
•
22
Emergency stop. Refer to section
Charge session. Refer to section
Danger:
General risk
• Make sure that you have approval of the manufacturer to use the
EVSE after commissioning. After approval, do not move the EVSE.
Caution: Remove condensation before use, to prevent damage to the
EVSE.
The EVSE stops all charge sessions.
The touchscreen shows a message.
The EVSE starts.
The message disappears from the touchscreen.
The EVSE resumes the normal operation.
4.2
.
4.4
.
4.7
emergency stop button.
1.12
.
7.6
.
4.8.1
.
.
BCM.S1101.0-EN | 001