Adjusting The Governor; Cleaning The Spark Arrestor; Maintenance Schedule - Champion 92001I-EU Operator's Manual

92001I - 2500W PORTAbLE INvERTER GENERATOR
7. Refer to the spark plug types in Specifications when
replacing the plug.
8. Firmly re-install the plug.
9. Attach the spark plug cable to the spark plug.
10. Reinstall the spark plug access cap and maintenance
cover.
Cleaning the Air Filter
1. Remove the maintenance cover.
2. Locate the air filter plastic cover. Remove the screw using
a Phillips head screwdriver.
3. Remove the foam element.
4. Wash in liquid detergent and water. Squeeze thoroughly dry
in a clean cloth.
5. Saturate in clean engine oil.
6. Squeeze in a clean, absorbent cloth to remove all excess
oil.
7. Place the filter in the assembly.
8. Reattach the air filter cover.
9. Reinstall the maintenance cover and tighten the cover
screw securely.
CAUTION
The filter element may contains PAHs, PAHs are harmful
for your health. Please wear gloves for protection during air
filter maintenance.

Cleaning the Spark Arrestor

1. Allow the engine to cool completely before servicing the
spark arrestor.
2. Remove the 6 screws holding the cover plate on the
muffler side of the generator.
3. Remove the screw which retains the spark arrestor to the
muffler.
4. Remove the spark arrestor screen.
5. Carefully remove the carbon deposits from the spark
arrestor screen with a wire brush.
6. Replace the spark arrestor if it is damaged.
7. Position the spark arrestor on the muffler and attach by
reversing the steps from above.
Failure to clean the spark arrestor will result in degraded
engine performance.
Federal and local laws and administrative requirements
indicate when and where spark arrestors are required.
When ordered, spark arrestors are required for operation
of this generator in National Forest lands. In California,
this generator must not be used on any forest-covered
land, brush-covered land, or grass-covered land unless the
engine is equipped with a spark arrestor.

Adjusting the Governor

Tampering with the factory set governor will void your
warranty.
The air-fuel mixture is not adjustable. Tampering with
the governor can damage your generator and your
electrical devices and will void your warranty. Contact our
Technical Support Team at +44 (0)1942 715 407 for all other
service and/or adjustment needs.

Maintenance Schedule

Follow the service intervals indicated in the following
maintenance schedule.
Service your generator more frequently when operating in
adverse conditions.
Contact our Technical Support Team at +44 (0)1942 715 407
to locate the nearest CPE certified service dealer for your
generator or engine maintenance needs.
19
OPERATION
CAUTION
NOTICE

WARNING
EN