Champion 92001I-EU Operator's Manual page 11

2500w portable inverter generator
Hide thumbs Also See for 92001I-EU:
Table of Contents

Advertisement

Available languages

Available languages

92001I - 2500W PORTAbLE INvERTER GENERATOR
ASSEMbLY
Your generator requires some assembly. This unit ships from
our factory without oil. It must be properly serviced with fuel
and oil before operation.
If you have any questions regarding the assembly of
your generator, call our Technical Support Team at
+44 (0)1942 715 407. Please have your serial number and
model number available.
Unpacking
1. Set the shipping carton on a solid, flat surface.
2. Remove everything from the carton except the generator.
3. Using the carrying handles of the unit, carefully remove
the generator from the box (two people lifting is
recommended).
Add Engine Oil
CAUTION
DO NOT attempt to crank or start the engine before it has
been properly filled with the recommended type and amount
of oil. Damage to the generator as a result of failing to follow
these instructions will void your warranty.
The generator rotor has a sealed, pre-lubricated ball bearing
that requires no additional lubrication for the life of the bearing.
The recommended oil type for typical use is 10W-30
automotive oil.
If running generator in extreme temperatures, refer to the
following chart for recommended oil type.
Recommended Oil Type / Tipo de aceite recomendado / Type d'huile recommandé
5W-30
5W-30 Synthetic / Sintético / Synthétique
°F
-20
0
20
40
°C
-28.9
-17.8
-6.7
4.4
Ambient temperature / Temperatura ambiente / Température ambiante
1. Place the generator on a flat, level surface.
2. Loosen the cover screws and remove the maintenance
cover.
NOTICE
NOTICE
10W-30
10W-40
60
80
100
120
15.6
26.7
37.8
48.9
3. Remove oil fill cap/dipstick to add oil.
4. Using a funnel, add up to 16.9 fl. oz. (0.5 qt.) of oil
(included) and replace oil fill cap/dipstick. DO NOT
OVERFILL.
5. Check engine oil level daily and add as needed.
MAX
MIN
Once oil has been added, a visual check should show oil
about 1-2 threads from running out of the fill hole.
When using the dipstick to check oil level, DO NOT screw in
the dipstick while checking.
11
ASSEMbLY
OIL DIP STICK
NOTICE
EN

Advertisement

Table of Contents
loading

Table of Contents