1
2
2
: Before fitting the gear housing
with its components, push the
blue wire (1) into the two slots (2)
and make sure it is secure.
3
2
: Place the gear housing (1) with
its components in the motor
housing (2).
: Fit the switch rod (3).
HSE 61, HSE 71, HSE 81
– Assemble the rear handle,
b 6.4.3.
– Close the rear handle, b 6.4.4.
– Install the drive gear, b 5.1.5.
– Close the housing, b 6.2.
1
7.4
Replacing front switch
rod
7.4.1
Removing the switch rod
– Open the housing, b 6.1.
: Remove the switch rod (1).
7.4.2
Installing the switch rod
: Fit the switch rod (1).
– Close the housing, b 6.2.
1
1
53