Table of Contents
Advertisement
charging pile is electrified and the robot is connected to pile correctly. Please note
the potential safety hazards caused by improper operation.
3.
Adapter charging (It is not recommended. It is forbidden to operate the
robot during adapter charging.)
When the robot battery is out of power and cannot be started, it can be
charged through the adapter according to the following steps:
① Turn off the power switch.
② Open the silicone cover outside the [Manual Charging Interface] on the
back of the robot, and connect the robot with the charging plug of the adapter.
③ After successful connection, the indicator lamp of the adapter turns red, and
the screen interface goes to the charging page, indicating that charging is in
progress.
④ When the indicator lamp of adapter turns green, charging is completed.
Please disconnect the adapter and plug the silicone cover outside the charging
interface of the robot.
Emergency Treatment
The user needs to push and move the robot with hand when it is in operation, or
press the emergency stop switch on the back of the robot to stop robot when it is
in abnormal operation state which may cause harm to the surrounding
environment or lead to other emergency situations. The position and operation
steps of emergency stop switch are shown in Fig. 5:
18 18 18 18 18 18 18
Hide quick links:
Advertisement
Table of Contents
