Start - Keenon Robotics PEANUT Product Manual

The robot needs to be familiar with the moving environment before moving
autonomously. It stores and identifies the running environment in the form of
map, and this step is called mapping. (It is completed by professional
technicians without user operation)
When the indoor environment of the robot changes greatly (such as
redecorating, moving the robot to a new operating place or rearranging indoor
items, etc.), please contact customer service staff at 400-9651-808 for
re-mapping.
2. Charging Pile Layout
The robot has the function of automatic recharging, so the charging pile
should be laid out in the convenient charging place inside its operating place,
and the installation is completed by the manufacturer's technicians. Please do
not move the charging pile without authorization once it is fixed, or contact
customer service staff at 400-9651-808 to reset the charging pile position.

Start

1. Start/Stop Power Button
Power switch is at the chassis behind the robot. Open the silicone cover
under the chassis, there is a button on the right, which is the power switch.
Find the position of the power switch as shown in Figure 3, press the power
switch to start the robot and observe that the blue lamp belt in the gap of
laser layer lights up. After started, the system can be used normally in about
40 seconds.
When the robot is to be turned off, please turn off the power switch in the
10 10 10 10 10 10 10