Table of Contents
Advertisement
5.
Hold the clock with the face down and align the clock-lock hanger with the bottom screw.
6.
Tilt the clock face to vertical and position the clock with the screw heads in the opening of the clock-lock hanger.
7.
Slide the clock down over the screw heads to latch it into place.
When the clock is powered-on it automatically connects to your facility's network to connect to its NTP time
source to synchronize its time and check-in to OneVue.
Update Clock Name
Update the name of a clock,
The name of a clock, bridge commonly identifies its install location. It's recommended to develop a standard naming
convention to allow devices to be located if maintenance should be required.
1.
Go to Devices > Clocks.
2.
From the list, select the Name link of the device. Its profile is displayed.
3.
From the Name field, enter its name. Allows up to a maximum of 50 characters.
4.
Select Save.
NOTE
Tip: If naming a Bluetooth Bridge, select Bridge instead of clocks in step 1 (above)
Primex Bluetooth products are shipped with a MAC address label that can be removed and placed on
building plans or a list of building locations that can be added to OneVue at your convenience.
Page 7
Advertisement
Table of Contents
