Shipment And On-Site Transport; Accepting The Delivered Goods; Removing The Packaging From The Regulator; Transporting And Lifting The Regulator - Samson 2357-3 Mounting And Operating Instructions

4 Shipment and on-site trans-
port
The work described in this section is only to
be performed by personnel appropriately
qualified to carry out such tasks.
4.1 Accepting the delivered
goods
After receiving the shipment, proceed as fol-
lows:
1. Check the scope of delivery. Check that
the specifications on the nameplate and
on the regulator itself match the specifi-
cations in the delivery note. See the
'Markings on the device' section for
nameplate details.
2. Check the shipment for transportation
damage. Report any damage to
SAMSON and the forwarding agent
(refer to delivery note).
Note
In the delivered state, the regulators are
packed to be free of oil and grease for oxy-
gen service.
Do not open or remove the packaging until
immediately before installation.
EB 2559 EN

Shipment and on-site transport

4.2 Removing the packaging
from the regulator
The regulator is delivered as an assembled
unit.
Î Do not open or remove the packaging
until immediately before lifting to install
the regulator into the pipeline.
Î Dispose and recycle the packaging in ac-
cordance with the local regulations.
NOTICE
!
In the delivered state, the regulators are
packed to be free of oil and grease for oxy-
gen service.
Do not remove the packaging until immedi-
ately before installation.
4.3 Transporting and lifting the
regulator
Due to the low service weight, lifting equip-
ment is not required to lift and transport the
regulator (e.g. to install it into the pipeline).
Transport instructions
Î Protect the regulator against external in-
fluences (e.g. impact).
Î Do not remove the packaging. Do not
open or remove the packaging until im-
mediately before installation in the pipe-
line.
Î Protect the regulator against moisture
and dirt.
4-1