Table of Contents
Advertisement
Adding Custom Words
You can add up to 10 installer-defined words to the built-in vocabulary, which can then be used
when programming zone descriptors. Each of the 10 words can actually consist of a word string of
one or more words, but no more than ten characters can be used for each word or word string.
When adding custom words, the keypad keys perform the following functions:
[4] Moves cursor one space to the left.
[6] Moves cursor one space to the right.
[8] Saves the new word in the system's memory.
1. Select Custom Word mode (enter 1) when the prompt "
2. Enter the number (01–10†) of the custom word or word string to be created, corresponding to
index numbers 245 - 254 respectively (for example, if you are creating the first custom word or
word-string, enter 01, for the second, enter 02, etc.). A cursor will now appear at the beginning of
the second line.
† or 11 for custom message. See Assigning Custom Message paragraph below.
NOTE: Custom words 8, 9, and 10 are "reminder words" that can be programmed to display using
Scheduling Mode.
3. Refer to the Character List of letters, numbers, and symbols on a following page.
Press [#], followed by the two-digit entry for the first letter you would like to display
(e.g., # 6 5 for "A").
The cursor will then move to the right, in position for the next character.
4. Repeat Step 3 to create the desired word(s). Note that the "4" key can be used to move the cursor
to the left, if necessary. Remember, no word or word-string can exceed 10 characters.
5. Press the [8] key to save the custom word(s) and return to the "
Repeat Steps 2–5 for other custom words to be entered. To change a custom word, just overwrite
it. If no more are to be entered now, press [0] to return to the Descriptor entry. The custom
word(s) will be automatically added to the built-in vocabulary.
Assigning Custom Message
You can create a custom message display that appears on alpha keypads instead of "System Ready."
To assign a custom message, use the same procedure as for adding custom words (described above),
but use word number 11 in step 2.
Use the SPACE bar to delete existing characters.
Once a custom word is entered, the system displays the custom message instead of the normal
"System Ready" message.
www.PDF-Zoo.com
firealarmresources.com
Alpha Descriptor Programming
" is displayed.
CUSTOM WORD ?
CUSTOM WORD ?
" display.
9-3
Advertisement
Table of Contents
