Configuring The Module For Firmware Upgrades; Factory And Bdm Jumpers; Gpo Jumpers; 7807Lt-2 Dual Wideband Rf Fiber Transmitter - evertz MultiFrame 7700 Manual

5.3.

CONFIGURING THE MODULE FOR FIRMWARE UPGRADES

UPGRADE: The UPGRADE jumper J5 is used when firmware upgrades are being done to the
module. For normal operation it should be installed in the RUN position. See the
Upgrading Firmware section of this manual for more information.
To upgrade the firmware:
1. Pull the module out of the frame.
2. Move the UPGRADE jumper into the UPGRADE position.
3. Install the Upgrade cable provided (located in the vinyl pouch in the front of this manual) onto the
SERIAL header at the card edge.
4. Re-install the module into the frame.
5. Run the upgrade as described in the Upgrading Firmware section of this manual.
6. When the upgrade is completed, remove the module from the frame, move the UPGRADE jumper into
the RUN position, remove the upgrade cable and re-install the module.
The module is now ready for normal operation.

If installed in a frame with a 7800FC/7700FC frame controller, the 7807LT-2 may also
be conveniently upgraded through Evertz VistaLINK
interruption. Consult VistaLINK
5.4.

FACTORY AND BDM JUMPERS

When shipped from the Evertz facility, the FACTORY and BDM jumpers will not be installed. These
jumpers should not be installed for any reason. If jumpers are on these positions they should be
removed.
5.5.

GPO JUMPERS

The Jumpers GPO1 and GPO2 allow user to select the behavior of Outputs of GPO's.
In NC (Normally Closed) jumper position of GPO1, an OPEN circuit is present between C (common) pin
and pin 1 of GPO connector and in NO (Normally Open) position of GPO1 a CLOSED circuit is present
between C (common) pin and pin 1 of GPO connector.
In NC (Normally Closed) jumper position of GPO2, an OPEN circuit is present between C (common) pin
and pin 2 of GPO connector and in NO (Normally Open) position of GPO2 a CLOSED circuit is present
between C (common) pin and pin 2 of GPO connector.
7700/7800 MultiFrame Manual

7807LT-2 Dual Wideband RF Fiber Transmitter

PRO documentation for details on this feature.
®
Revision 1.2
PRO, without service
®
Page - 13