Advanced Range Optimization; Propulsion Control Module (Pcm); Description - Mercury V6 175 Diagnostic Manual

System Theory
When the engine first starts, if there is a failure with the O2 sensor, or if for some reason, such as a failed fuel injector or spark
plug, the information reported by the sensor would require the PCM to add or subtract an excessive amount of fuel, the PCM
may revert to a default fuel table. It is then considered in open‑loop operation and will continue to use the last known good
values.
Closed‑Loop Control Summary
Step
1 PCM calculates air/fuel ratio.
2 Fuel system delivers the required air/fuel ratio to the combustion chamber.
3 Combustion occurs (power stroke).
4 Exhaust gases enter the exhaust manifold (exhaust stroke).
5 The oxygen sensor sends a signal to the PCM, delivering oxygen information.
The cycle returns to step 1.
The speed/density system depends on the engine being unmodified from its original production state. If the engine is modified
and its volumetric efficiency changes, the amount of air flow for a given RPM and air density will change, causing the fuel
injector operation calculated by the PCM to be incorrect.

Advanced Range Optimization

Advanced range optimization (ARO) is a software based feature which actively increases fuel economy under specific
operating conditions. It becomes active when the engine is set within a defined RPM range, and certain load conditions are
met. The status of ARO can only be monitored using CDS G3. In CDS G3, ARO is called Lean Burn. The main data point in
CDS G3 is LeanBurnCtrlState. To learn more about ARO, and lean burn control states, an informative video can be found at:
https://p.widencdn.net/dxaed0/Advanced‑Range‑Optimization.

Propulsion Control Module (PCM)

The propulsion control module (PCM) system monitors sensor inputs and controls fuel delivery and spark timing. Its
components are:
• PCM 112 assembly
• Wiring harness
• Input devices (sensors)
• Output devices (fuel injectors, ignition coils, etc.)

Description

The PCM 112 is a 112‑pin propulsion control module that manages engine conditions and closed‑loop engine operation based
on oxygen sensor feedback. The PCM 112 requires the use of a separate PCM power harness.
The PCM monitors the following engine sensor feedback to control fuel injector timing, pulse width, and ignition spark timing:
• Block water pressure sensor
• Camshaft position sensor
• Crankshaft position sensor
• Engine coolant temperature (ECT) sensor
• ESTOP or lanyard switch position
• Exhaust gas temperature (EGT) sensor
Page 1B-4
Fuel System
Combustion
Closed-loop operation
© 2018 Mercury Marine
PCM
O Sensor
2
67455
Action
90-8M0146617 eng JULY 2018