Supermicro SuperServer E403-9D-4C-FRDN13+ User Manual page 81

PCH sSATA Configuration

When this submenu is selected, the AMI BIOS automatically detects the presence of the
SATA devices that are supported by the Intel PCH chip and displays the following features:
sSATA Controller
This feature enables or disables the onboard sSATA controller supported by the Intel PCH
chip. The options are Enable and Disable.
Configure sSATA as
Select AHCI to configure an sSATA drive specified by the user as an AHCI drive. Select RAID
to configure an sSATA drive specified by the user as a RAID drive. The options are AHCI
and RAID.
SATA HDD Unlock
This feature allows you to remove any password-protected SATA disk drives. The options
are Disable and Enable.
*If the feature Configure sSATA as above is set to RAID, sSATA RSTe Boot Info and
sSATA RAID Option ROM/UEFI Driver will be available for configuration:
sSATA RSTe Boot Info
Select Enable to provide full int13h support for the devices attached to sSATA controller. The
options are Disable and Enable.
Aggressive Link Power Management
When this feature is set to Enable, the SATA AHCI controller manages the power usage of
the SATA link. The controller will put the link in a low power mode during extended periods
of I/O inactivity and will return the link to an active state when I/O activity resumes. The op-
tions are Disable and Enable.
sSATA RAID Option ROM/UEFI Driver
Select UEFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for
system boot. The options are Disable, EFI, and Legacy.
sSATA Port 0 ~ Port 4
This feature displays the information detected on the installed sSATA drive on the particular
sSATA port.
•
Model number of drive and capacity
•
Software Preserve Support
81
Chapter 5: UEFI BIOS