Supermicro SuperServer E403-9D-4C-FRDN13+ User Manual page 58

SuperServer E403-9D-4C/14CN/16C-FRDN13+ User's Manual
Watch Dog
JJWD1 controls the Watch Dog function. Watch Dog is a monitor that can reboot the system
when a software application hangs. Jumping pins 1-2 will cause Watch Dog to reset the system
if an application hangs. Jumping pins 2-3 will generate a non-maskable interrupt signal for
the application that hangs. Watch Dog must also be enabled in BIOS.
Note: When Watch Dog is enabled, users need to write their own application software
to disable it
LAN Port Enable/Disable
Change the setting of jumpers JPL1 for LAN1, JPL2 for LAN2 - LAN5, and JPL3 for LAN6 -
LAN9 to enable or disable the LAN ports.
TPM Enable
Use JPT1 to enable or disable support for the TPM module. Refer to the table below for
jumper settings.
M.2 SMBus Enable
Use J1 to enable or disable the M.2 SMBus. Refer to the table below for jumper settings.
Watch Dog
Jumper Settings
Jumper Setting Definition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
LAN Port Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
TPM Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
M.2 SMBus Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
58