Integrating Equations ( ∫ Fn) - HP 35s User Manual

Integrating Equations ( ∫ FN)
To integrate an equation:
1. If the equation that defines the integrand's function isn't stored in the equation
list, key it in (see "Entering Equations into the Equation List" in chapter 6) and
leave Equation mode. The equation usually contains just an expression.
2. Enter the limits of integration: key in the lower limit and press
key in the upper limit.
3. Display the equation: Press
equation list (press
4. Select the variable of integration: Press
calculation.

uses far more memory than any other operation in the calculator. If executing

causes a   message, refer to appendix B.
You can halt a running integration calculation by pressing
message "" will be shown in line 2, but the integration cannot be
resumed. However, no information about the integration is available until the
calculation finishes normally.
The display format setting affects the level of accuracy assumed for your function
and used for the result. The integration is more precise but takes much longer in the
 and higher , , and  settings. The uncertainty of the result ends up
in the Y–register, pushing the limits of integration up into the T– and Z–registers. For
more information, see "Accuracy of Integration" later in this chapter.
To integrate the same equation with different information:
If you use the same limits of integration, press
Y–registers. Then start at step 3 in the above list. If you want to use different limits,
begin at step 2.
To work another problem using a different equation, start over from step 1 with an
equation that defines the integrand.
8-2
Integrating Equations

and, if necessary, scroll through the
× Ø
or ) to display the desired equation.
 
variable. This starts the

 
move them into the X– and

, then

or ,and the