Viewing Fault Or Isolate Conditions; Overview - Simplex 4100 Operator's Manual

Viewing Fault or Isolate Conditions

Overview

You can view the list of acknowledged fault or isolate conditions at any time by using the
following procedure.
1.
2.
Press the <FAULT ACK> or <ISOLATE ACK> key to enter the fault or isolate list. The
first fault or isolate condition in the list appears in the display. The top line indicates the
custom label of the point. The bottom line contains two parts. The left side of the bottom
line shows the type of device. The right side of the bottom line identifies the type of
condition, fault or isolate.
At this point, each time you press the <FAULT ACK> or <ISOLATE ACK> key, the
next point in the list appears. (You can also use the <NEXT> and <PREV> keys to do
this.
firealarmresources.com
3-4