How To Exit Walk Test Mode - Simplex 4100 Operator's Manual

Walk Test™ PROCEDURES,
How to Enter Walk
Test Mode,
5.
(continued)
To enable multiple Walk Test™ groups, press the <NEXT> key to scroll to the next Walk
Test™ group. Then press the <F1> key to enable that group. Continue scrolling, then press
the >F1> key to select required Walk Test™ groups. Once all Walk Test™ groups are
selected, press the fault acknowledge key, then continue. When a Walk Test™ group with no
configured points is selected, the display shows the following message.
Note:
How to Exit Walk
When the Walk Test™ has been satisfactorily completed, exit from the Walk Test™ mode by
Test Mode
performing the following procedure.
1.
2.
3.
4.
Note:
5.
6.
7.
8.
9.
Continued
Press the F1> key to enable/disable the Walk Test™ mode. The SYSTEM FAULT LED
illuminates, the tone-alert sounds, and the LCD displays the following message.
F1 = ON>off F2 = no>LOG F3 = ?>ZONE F4 = NO<sig
WALK TEST GROUP 0
No walk test points configured for:
WALK TEST GROUP X
X equals 0 through 7.
Press the <MENU> key.
Press the <NEXT> key to select the Walk Test™ function.
Press the <ENTER> key.
Press the <F1> key to turn off a Walk Test™ group. Press NEXT, then <F1> to turn OFF
each enabled Walk Test™ group.
The system activates a one-minute timer when exiting from the Walk Test™ mode.
This timer ensures that monitor points have had ample time to clear (smoke) prior to
enabling the system. After the one-minute delay, the system Walk Test™ fault
automatically clears.
Press <MENU>. The Change Access Level menu is shown.
Press <ENTER>.
Press <F2> to log out.
If Access Level 4 was entered, fault will continue to exist in the system. Access Level 4
is normally used by Simplex personnel and additional steps must be performed. Call
Simplex to restore the system.
Inform required personnel when system testing is completed.
firealarmresources.com
10-9
Continued on next page