Appliance Led Activation; Procedure - Simplex 4100 Operation

Front panel

Hide thumbs Also See for 4100:

Table of Contents

Appliance LED Activation

Note:

In order for Diagnostics to operate properly all appliances must

be inactive prior to diagnostic activation.

Use the following procedure to activate all of the TrueAlert Appliance LEDs

assigned to a particular TrueAlert Addressable Controller.

Log on the 4100/4020 at the appropriate Access Level.

On the Operator Interface Panel, go to the TrueAlert appliance function

screen and turn on the appliance LEDs on the TrueAlert Addressable

Controller. Verify that all of the appliance LEDs assigned to the TrueAlert

Addressable Controller turn on. (The 4100/4020 display will remained

locked onto this screen for eight hours or until you turn off the LEDs.)

From the Operator Interface Panel display under the TrueAlert appliance

function screen, turn off the appliance LED's on the TrueAlert

Addressable Controller.

If more than one TrueAlert Addressable Controller is connected to the system

repeat the above procedure on the remaining Addressable Controllers.

3-4

firealarmresources.com

Table of Contents