Adj Led Rc3 Infrared Remote - ADJ FLAT PAR TW12 User Manual

A D J L E D R C 3 I N F R A R E D R E M O T E
The ADJ LED RC3 Infrared Remote (sold separately) gives you complete control of your fixture. For
best results, the controller must be aimed at the front of the fixture and be within the maximum operating
range of 30 feet. To use the ADJ LED RC3, you must first activate the fixture's infrared receiver, as
shown in the System Menu section of this manual.
BLACKOUT - Pressing this button will blackout the fixture.
AUTO RUN - Pressing this button will cycle through the auto run mode, color fade mode, and color
change. You can control the speed of the 3 modes by pressing the SPEED button first, then pressing
the "+" and "-" buttons. In color fade and color change mode, press the "+" and "-" buttons to scroll
through the 8 modes.
PROGRAM SELECTION - Pressing this button activates static color mode. Use the "+" or "-" to scroll
through the 32 colors. Press Flash to activate/deactivate strobing. Use the "+" and "-" buttons to adjust
the strobe speed.
DMX MODE - Press this button to cycle between DMX Channel mode selection, DMX addressing, DMX
State, and dimming curve selection. Each press of this button will change to the next mode.
• In DMX State mode, press the the "+" and "-" buttons to scroll through the DMX state modes. See
the System Menu section of this manual for detailed information.
• In DMX address mode, press the the "+" and "-" buttons to adjust the DMX address.
• In dimmer curve mode, press the the "+" and "-" buttons to scroll through the dimmer curves. See
the System Menu section of this manual for detailed information.
• In DMX Channel selection, press the the "+" and "-" buttons to scroll through the different DMX
Channel modes. See the Operating Instructions section of this manual for detailed information. The
fixture's LEDs will glow in different colors to signify the selected DMX Channel Mode, as described
in the table below:
Warm White & Cool White
Warm White & Amber
SOUND ACTIVE - This button activates sound active mode. Use the "+" and "-" buttons to scroll through
the 8 sound active modes. Press the Speed button and use the "+" and "-" buttons to adjust the sound
sensitivity level.
SECd - This designates the fixture as a secondary fixture in a primary/secondary configuration.
SET ADDRESS - Press this button to set the DMX address. Press this button first, then use the number
keypad to set the address.
Note: When setting the DMX address, an LED color will glow each time a key is pressed. When you
have set the DMX address correctly, all LED's will flash 2-3 times.
Example: To Set DMX Address 1, Press "S-0-0-1" To Set DMX Address 245, Press "S-2-4-5".
WW CW A - Press either one of these buttons and the press the "+" or "-" to adjust the output intensity.
Press Flash to activate/deactivate strobing. Use the "+" and "-" buttons to adjust the strobe speed.
LED COLOR
Warm White
Cool White
Amber
Wool White & Amber
DMX CHANNEL MODE
2 Channel Mode
3 Channel Mode
4 Channel Mode
5 Channel Mode
8 Channel Mode
9 Channel Mode
16