Operation; Infrared Remote - ADJ ECO UV BAR PLUS IR User Instructions

O P E R AT I O N
The ADJ Eco UV Bar Plus IR contains an electronic ballast, which will auto sense the voltage when it is
plugged into the power source. With the electronic voltage switch, you do not need to worry about wall
voltage as this unit can be plugged in anywhere. This fixture is designed to operate as a stand alone
unit with no extra assembly necessary. The Eco UV Bar Plus IR is ready to be plugged in out of the box.
Plug the unit in to a matching power outlet or into a power pack, and "flip" the power switch to the On
position. Use the included UC IR to control the unit.
NOTE: A maximum of 10 fixtures can be connected in a daisy chain. Do not mix fixtures as the
results are unpredictable and could be catastrophic.
I N F R A R E D R E M O T E
The UC IR infrared remote (Included) gives you control of various functions (See below). To control the
fixture you must aim the remote at the front of the fixture and be no more than 30 feet away.
The Airstream IR (sold separately) remote transmitter plugs into the headphone jack of your iOS
phone or tablet. To control your IR fixture you must raise the volume to the maximum on your iOS phone
or tab- let and aim the transmitter at the fixture sensor and be no more than 15 feet away. After you
have purchased the Airstream IR transmitters, the app is a free download from the app store for your
iOS phone or tablet. The app comes with 3 pages of control depending on the fix- ture you are using.
Please see below for IR functions. This unit works with App page 1.
STAND BY - Pressing this button will blackout the fixture. FULL ON - Press this button down to fully
light up the unit.
FADE/GOBO - Press this button to activate UV fade mode. Press button 1 for slow fade, button 2 for
medium fade, and button 3 for fast fade.
"DIMMER +" and "DIMMER -" - Use these buttons to adjust the out- put intensity when UV color mode
is active.
STROBE - Press this button to activate strobing. Press button 1 for slow strobe, button 2 for medium
strobe, button 3 for fast strobe, and button 4 for the fastest strobing.
COLOR - Press this button to activate UV color mode. Adjust the output intensity using the
"DIMMER +" and "DIMMER -" buttons.
1-9 - When in strobe use buttons 1-4 to adjust the strobe rate. In fade mode use buttons 1-3 to adjust
the fade speed.
SOUND ON & SOUND OFF - These buttons are invalid for this fixture.
- This button is invalid for this fixture.
SHOW
10-meters is the maximum effective
range of the IR Remote
8