Remote Control - ADJ ACCU-STAND CSL100 User Manual

R E M O T E C O N T R O L
PAIRING: The original remote that comes in the box is already paired to the unit. In the event that the
remote is not paired with the unit, or if pairing to an additional unit, follow the stops below:
1. Unplug the power to the main unit and reconnect the power after ten seconds.
2. Press the "Red" and "Blue" keys together within 5 seconds of powering the unit on. The unit will
toggle between 6 color combinations and the sequence will be memorized.
CHANGE OUTPOUT COLOR SEQUENCE: The default output color sequence is: Green, Red, and
Blue. If for any reason, the unit is displaying a different sequence, or the Direct Color Select keys do
not match, the unit can be reconfigured by following the stps below:
1. Unplug the power to the main unit and reconnect the power after ten seconds.
2. Press the "Red" and "Blue" keys together within 5-seconds of powering the unit on. The unit will
toggle between 6 color combinations and the sequence will be recorded.
POWER
Turns the unit ON and restores the unit to previous status. If the unit is
on, the unit will enter standy mode.
DEMO
Play 17 dynamic modes in a loop. Each mode repeats 3 times.
MODE +/-
This button lets you cycle thorugh color fade mode, color change
mode, and auto run modes. Each button press will cycle to the next
mode. There are 22 different programs. You can use the "+" and "-"
buttons to cycle through the 22 programs.
SPEED +/-
There are 10 available speeds. Select the speed using the "SPEED+"
or "SPEED-" buttons.
COLOR +/-
There are 20 available colors. Select the color using the "COLOR+" or
"COLOR-" buttons.
BRIGHT+/-
There are 5 available brightness levels. Adjust the brightness using
the "BRIGHT+" or "BRIGHT-" buttongs.
DIRECT COLOR SELECTION BUTTONS
There are 7 color shortcut keys representing static colors. These colors are also available via the
COLOR+/- selections.
14