ADJ FLAT PAR TW12 User Manual page 15

S Y S T E M M E N U
Primary-Secondary Operation:
This function will allow you to link units together, with one unit acting as the controlling unit and the
others reacting to the behavior of the controlling unit. Any unit can act as a Primary or as a Secondary,
but only one unit in a given system can be programmed to act as the Primary.
1. Using approved DMX data cables, daisy chain your units via the XLR connectors on the rear of the
units. Remember the Male XLR connector is the input and the Female XLR connector is the output.
The first unit in the chain (primary) will use the female XLR connector only, while the last unit in the
chain will use the male XLR connector only. For longer cable runs, it is strongly recommended to
use a terminator on the last fixture.
2. Set the Primary unit to the desired mode of operation.
3. For the Secondary unit(s), press the MODE button until "SECd" is displayed. The Secondary unit(s)
will now follow the Primary.
15