Installation Instructions - ADJ FLAT PAR TW12 User Manual

I N S TA L L AT I O N I N S T R U C T I O N S
DO NOT INSTALL THE FIXTURE IF YOU ARE NOT QUALIFIED TO DO SO!
Fixture MUST be installed following all local, national, and country commercial electrical and construction
codes and regulations.
Before rigging/mounting a single fixture or multiple interconnected fixtures to any metal truss/structure
or placing the fixture(s) on any surface, a professional equipment installer MUST be consulted to
determine if the metal truss/structure or surface is properly certified to safely hold the combined weight
of the fixture(s), clamps, cables, and accessories.
Maximum ambient operating temperature is 104°F. (40°C)
Fixture(s) should be installed in areas outside walking paths, seating areas, or away from areas where
unauthorized personnel might reach the fixture by hand.
NEVER stand directly below the fixture(s) when rigging, removing or servicing.
OVERHEAD RIGGING
Overhead rigging requires extensive experience, including calculating working load limits, installation
material being used, and periodic safety inspection of all installation material and the fixture, among
other skills. If you lack these qualifications, DO NOT attempt the installation yourself. Improper
installation can result in bodily injury and property damage.
Overhead fixture installation must always be secured with a secondary safety attachment, such as an
appropriately rated safety cable that can hold 10 times the weight of the fixture. Before servicing, allow
approximately 15 minutes for the fixture to cool down before serving.
POWERING MULTIPLE UNITS
When installing, you can use the IEC input and output sockets to connect a maximum of 25 fixtures.
The fixtures must be of the same make and model. DO NOT mix fixtures.
WHEN INSTALLING THE FIXTURE IN A SUSPENDED ENVIRONMENT, ALWAYS
ATTACH AN INDEPENDENT SAFETY CABLE BETWEEN THE TRUSS/STRUCTURE
AND THE FIXTURE IN ORDER TO ENSURE THAT THE FIXTURE WILL NOT FALL IF
THE CLAMP FAILS!
NEVER DAISY CHAIN MULTIPLE SAFETY CABLES TOGETHER BETWEEN MULTIPLE
FIXTURES! EACH FIXTURE MUST HAVE ITS OWN, INDEPENDENT SAFETY CABLE!
10