Analog Delay - Boss GX-100 Parameter Manual

EFFECTS

ANALOG DELAY

Gives a mild analog delay sound.
Parameter Value
ON/OFF OFF, ON
MONO
TYPE
DIR/EFX
12 ms–1200
ms, BPM ŀ–Ō
TIME
0–100
FEEDBACK
EFFECT 0–120
LEVEL
DIRECT 0–120
LEVEL
20.0 Hz–12.5
HIGH CUT
kHz, FLAT
MOD RATE 0–100
MOD DEPTH 0–100
0–100
DUCK SENS
0–100
DUCK PRE
CARRYOVER OFF, ON
0–100
DUCK POST
CARRYOVER OFF, ON
40–250
BPM
42
Chain
Turns this effect on/off.
This is a simple mono delay.
This is a stereo-in/out delay.
Adjusts the delay time.
* When set to BPM, the value of each parameter will be set according to the value of the
"MASTER BPM" specified for each memory. This makes it easier to achieve effect sound
settings that match the tempo of the song.
* If, due to the tempo, the time is longer than the range of allowable settings, it is then
synchronized to a period either 1/2 or 1/4 of that time.
Adjusts the volume of delay that is returned to the input. Higher values increase the number of
delay repeats.
Adjusts the volume of the delay sound.
Adjusts the volume of the direct sound.
Sets the frequency at which the high cut filter begins to take effect. When FLAT is selected, the
high cut filter has no effect.
Adjusts the modulation rate of the delay sound.
Adjusts the modulation depth of the delay sound.
Adjusts the sensitivity by which the volume is automatically adjusted according to the input.
Increasing this value makes the response more sensitive at lower volumes.
The volume being "input" to the delay is automatically reduced when the input sound is loud. As
this setting approaches 100, the output volume reduction is applied more deeply.
Sets whether to make the sound of the effect carry over or not after you turn it off.
The volume being "output" to the delay is automatically reduced when the input sound is loud. As
this setting approaches 100, the output volume reduction is applied more deeply.
Sets whether to make the sound of the effect carry over or not after you turn it off.
Adjusts the BPM value for each memory.
* BPM (beats per minute) indicates the number of quarter note beats that occur each minute.
* When you have an external MIDI device connected, the MASTER BPM synchronizes to the
external MIDI devices tempo, making it impossible to set the MASTER BPM. To enable setting
of the MASTER BPM, set "SYNC CLOCK" to "INTERNAL".
Palette
Explanation