Boss GX-100 Parameter Manual page 97

Parameter
MODE
ACT LOW
ACT HIGH
SENS
INTERNAL TRIGGER *1
PEDAL(P.113)
TIME *1
CURVE *1
WAVE FORM *2
PEDAL(P.113)
Value
EXP 1 Assigns the GX-100's expression pedal.
EXP 2 Assigns the external expression pedal connected to the CTL 3, 4/ EXP 2 jack.
INT PDL Assigns the internal
pedal.
WAVE PDL Assigns the wave
pedal.
INPUT The assigned target parameter will change according to the input level.
CC# 1–31, 64–95 Control Change messages from an external MIDI device.
MOMENT The normal state is Off (minimum value), with the switch On (maximum
value) only while the footswitch is depressed.
TOGGLE The setting is toggled On (maximum value) or Off (minimum value) with
each press of the footswitch.
0–126 You can set the controllable range for target parameters within the source's
operational range.
1–127
Target parameters are controlled within the range set with ACT LOW and
ACT HIGH.
You should normally set ACT LOW to 0 and ACT HIGH to 127.
0–100 This adjusts the input sensitivity when INPUT is selected for SOURCE.
MEMORY This is activated when memory is selected.
CHANGE
EXP1 PDL-LOW This is activated when the GX-100's expression pedal is set to the minimum
position.
EXP1 PDL-MID This is activated when the GX-100's expression pedal is moved through the
middle position.
EXP1 PDL-HIGH This is activated when the GX-100's expression pedal is set to the maximum
position.
EXP1 SW This is activated when the [EXP 1] switch is operated.
NUM1–NUM4 This is activated when the [1]–[4] switch is operated.
CUR NUM This is activated when you operate the same number switch as the selected
memory number.
EXP 2 This is activated when an external expression pedal connected to the CTL 3,
4/ EXP 2 jack.
CTL 1, CTL 2 This is activated when the [C1]–[C2] switch is operated.
CTL 3, CTL 4 This is activated when an external footswitch connected to the CTL 3, 4/ EXP
2 jack is operated.
BANK à
This is activated when the BANK [Ç] switch is operated.
BANK á
This is activated when the BANK [É] switch is operated.
CC#1–31, 64–95 This is activated when a control change is received.
0–100 This specifies the time over which the internal pedal will move from the toe-
raised position to the toe-down position.
LINEAR
SLOW RISE
FAST RISE
SAW
TRI
SINE
Explanation
Refer to "Virtual Expression Pedal System (Internal
Pedal / Wave Pedal)".
CTL/EXP
97