Flanger - Boss GX-100 Parameter Manual

FLANGER

The flanger effect gives a twisting, jet-airplane-like character to the sound.
Parameter Value
ON/OFF OFF, ON
0–100, BPM
ŀ–Ō
RATE
DEPTH 0–100
0–100
RESONANCE
MANUAL 0–100
FLAT, 20.0
LOW CUT
Hz–12.5 kHz
OFF, 0–100,
STEP RATE
BPM ŀ–Ō
EFFECT 0–100
LEVEL
DIRECT MIX 0–100
40–250
BPM
Chain
Turns this effect on/off.
Sets the rate of the flanging effect.
* When set to BPM, the value of each parameter will be set according to the value of the
"MASTER BPM" specified for each memory. This makes it easier to achieve effect sound settings
that match the tempo of the song.
* If, due to the tempo, the time is longer than the range of allowable settings, it is then
synchronized to a period either 1/2 or 1/4 of that time.
Determines the depth of the flanging effect.
Determines the amount of resonance (feedback). Increasing the value emphasizes the effect, for a
more unusual sound.
Adjusts the center frequency at which to apply the effect.
Sets the frequency at which the low cut filter begins to take effect. When "FLAT" is selected, the low
cut filter has no effect.
This sets the cycle of the step function that changes the rate and depth. When it is set to a higher
value, the change will be finer. Set this to "0" when not using the Step function.
Adjusts the volume of the flanger.
Adjusts the volume of the direct sound.
Adjusts the BPM value for each memory.
* BPM (beats per minute) indicates the number of quarter note beats that occur each minute.
* When you have an external MIDI device connected, the MASTER BPM synchronizes to the
external MIDI devices tempo, making it impossible to set the MASTER BPM. To enable setting
of the MASTER BPM, set "SYNC CLOCK" to "INTERNAL".
Palette
Explanation
EFFECTS
21