Midi; Midi Setting - Boss GX-100 Parameter Manual

MIDI

Here you can make settings for using the GX-100 connected with an external MIDI device or with a second GX-100 unit.

MIDI SETTING

Parameter Value
RX This sets the MIDI channel used for receiving MIDI messages.
CHANNEL
CH1–CH16
Sets the MIDI channel used for transmitting MIDI messages.
TX
CH1–CH16
CHANNEL
RX CH
This specifies the connector from which to output the MIDI messages that are received at the MIDI IN connector.
OFF
MIDI IN
MIDI OUT
THRU
USB OUT
USB & MIDI Output from the USB port and the MIDI OUT connector.
This specifies the connector from which to output the MIDI messages that are received at the USB port.
OFF
USB IN
MIDI OUT
THRU
USB OUT
USB & MIDI Output from the USB port and the MIDI OUT connector.
This setting determines the basis used for synchronizing the timing for effect modulation rates and other time-
based parameters.
* When you have an external MIDI device connected, the MASTER BPM is then synchronized to the external
MIDI device's tempo, thus disabling the MASTER BPM setting. To enable setting of the MASTER BPM, set to
"INTERNAL".
* When synchronizing performances to the MIDI Clock signal from an external MIDI device, timing problems in
the performance may occur due to errors in the MIDI Clock.
SYNC
CLOCK
AUTO
INTERNAL
MIDI
(AUTO)
USB (AUTO)
Specifies whether MIDI clock will be output from the GX-100.
CLOCK OUT OFF
ON
NUM1 CC# Specifies the controller number when transmitting pedal operations as control change messages.
NUM2 CC#
OFF
NUM3 CC#
NUM4 CC#
BANK
á CC#
BANK
à CC#
CC#1–
EXP1 SW CC#31,
CC# CC#64–
CTL1 CC# CC#95
CTL2 CC#
CTL3 CC#
CTL4 CC#
EXP1 CC#
EXP2 CC#
Specifies the receive channel.
Specifies the transmit channel.
Transmits on the same channel as the RX CHANNEL.
MIDI messages are not transmitted.
Messages are transmitted from the MIDI OUT connector.
Messages are transmitted from the USB port.
MIDI messages are not transmitted.
Messages are transmitted from the MIDI OUT connector.
Messages are transmitted from the USB port.
Operations are synchronized to MIDI clock messages received via MIDI or USB. However, operations
are automatically synchronized to the GX-100's internal clock if the GX-100 is unable to receive the
external Clock.
Operations are synchronized to the GX-100's internal Clock.
Operations are synchronized to the MIDI Clock received via MIDI. However, operations are
automatically synchronized to the GX-100's internal clock if the GX-100 is unable to receive the
external Clock.
Operations are synchronized to the USB Clock received via USB. However, operations are
automatically synchronized to the GX-100's internal clock if the GX-100 is unable to receive the
external Clock.
MIDI clock is not output.
MIDI clock is output.
Control Change messages are not output.
Pedal operations are transmitted using the specified controller number.
Explanation
MENU
123