Using The Tempo Delay; Begin Inputting The Tempo; Finish Inputting The Tempo - Boss Digital Delay DD-6 Owner's Manual

Using the Tempo Delay

You can set the delay time to match the tem-
po by pressing the pedal switch to the tempo
of the song being played. You can also
change the delay time as you perform.
Using tempo input, the delay time can be set
within the range of 0.2–2.6 seconds.
* With long delay, the maximum setting is 5.2 seconds.
You can set this regardless of whether the ef-
fect is on or off.
1. Select the mode
Use the MODE switch to select the mode
to be used.
* Tempo input cannot be used in HOLD and
WARP modes.
2. Switch to TEMPO mode
Hold down the pedal switch for at least
two seconds
(the CHECK indicator alternate-
ly flashes red and green)
12
.
* When the basic tempo has not been determined,
then even if you switch to TEMPO mode, the
delay time switches to the setting mode (the
position of the D.TIME knob).

3. Begin inputting the tempo

Press the pedal switch in time with the
song tempo (converted to quarter notes as
the basic tempo).

4. Finish inputting the tempo

Hold down the pedal switch for at least
two seconds to complete the setting
CHECK indicator lights red)
* The tempo may become confused momentarily
when you go from Step 3 to Step 4.
* If you move the D.TIME knob after finishing
this setting, the delay time corresponding to the
knob position takes effect.
* The basic tempo is preserved even when the
mode is switched.
(the
.