Configuring The Option Module; Configuration Tools - Rockwell Automation Allen-Bradley PowerFlex 20-750-PNET User Manual

Configuration Tools

Configuring the Option Module

This chapter provides instructions and information for setting the parameters
to configure the option module.
Topic
Configuration Tools
Using the PowerFlex 20-HIM-A6 or 20-HIM-C6S HIM to Access Parameters
Setting the IP Address, Subnet Mask, and Gateway Address
Setting a Leader-Follower Hierarchy (Optional)
Setting a Fault Action
Resetting the Option Module
Restoring Option Module Parameters to Factory Defaults
Viewing the Option Module Status Using Parameters
Updating the Option Module Firmware
Configure the Option Module on Your PROFINET Network
For a list of parameters, see
definitions of terms in this chapter, see the Glossary.
The option module stores parameters and other information in its own
nonvolatile storage (NVS) memory. You must, therefore, access the option
module to view and edit its parameters. The following are the recommended
tools to access the option module parameters.
Tool
PowerFlex® 20-HIM-A6 or
20-HIM-C6S HIM
Connected Components
Workbench™ software
IMPORTANT For the HIM screens shown throughout this chapter, the option
module was installed in Port 4. If your option module is installed in a
different port, that port would appear instead of Port 4.
Rockwell Automation Publication 750COM-UM007B-EN-P - December 2020
Appendix B, Option Module
See
page 26
Connected Components Workbench software website and online help
/rok.auto/ccw
3
Chapter
Page
25
26
26
28
30
31
32
32
33
33
Parameters. For
http:/
25