Table of Contents
Advertisement
Reconfiguring Module
Parameters in Run Mode
Reconfiguring Module
Parameters in Program
Mode
Use this pull-down menu to
switch to Program mode
Use this pull-down
menu to download the
new configuration.
Publication 1756-UM525A-EN-P - June 2003
Your module can operate in Remote Run mode or Hard Run mode. You can
only change any configurable features that are enabled by RSLogix 5000 in
Remote Run mode.
If any feature is disabled in either Run mode, change the controller to Program
mode and make the necessary changes.
Follow these steps to change configuration in Program mode.
1. Make sure the module is in Program Mode.
2. Make any necessary changes.
3. Download the new configuration.
4. Return to Run Mode, if necessary.
Configuring the 1756-HYD02 Module
Chapter 3
39
Advertisement
Table of Contents
