Table of Contents
Advertisement
Isco 4700 Refrigerated Sampler
Section 3 Programming
3.2 Getting Started
3-2
Table 3-1 Control Buttons (Continued)
Icon
Name
Description
Previous Selects the previous menu option left or above the
current choice.
Next
Selects the next menu option right or below the cur-
rent choice.
Stop,
Stops the pump or distributor. Pauses a running
Cancel,
sampling program. In programming screens, returns
or Exit
to the previous programming level.
Calibrate Press this button from the Main Menu to enter the
Calibration mode.
Grab
Press this button from the Main Menu or the Paused
Sample
state to take a grab (manual) sample.
Enter
Accepts a menu choice or number entry and goes to
next screen.
Run
Press this button to start the sampling program.
Program
Apply power to the sampler (see section 2.9). The start-up screens
appear on the LCD display.
After completing the start-up routine, turn the sampler on by
pressing the Power button. The control panel displays the Main
Menu screen and waits for your input.
PROGRAM
The Main Menu screen displays three menu options. The active
option blinks. To change the active option, use the Next and Pre-
vious buttons. Press the Enter button to choose the blinking
active option.
If you have just installed the sampler, you will first need to con-
figure the sampler (section 3.3). Next, you will need to program it
for operation (section 3.4). The View Log option (section 4.3) will
not contain meaningful data until you have run a sampling
program.
Copyright 2006
TELEDYNE ISCO
4700 SAMPLER
CONFIGURE
VIEW LOG
Advertisement
Table of Contents
