Table of Contents
Advertisement
Isco 4700 Refrigerated Sampler
Section 2 Installation
2.4.3 4 Bottles
2.4.4 2 Bottles
Figure 2-5
Installing the locating base
2-8
The four bottle configuration uses a locating base to hold and
align the bottles. To install the base and bottles:
1. Slide the locating base into the bottom of the refrigerated
compartment (Figure 2-5). Note that the arrow must be
pointing toward the back of the refrigerator.
2. Insert the four uncapped bottles into the numbered holes
in the locating base.
Note
Bottle caps can be stored between the bottles.
The two bottle configuration uses a locating base to hold and
align the bottles. To install the base and bottles:
1. Slide the locating base into the bottom of the refrigerated
compartment (Figure 2-5). Note that the arrow must be
pointing toward the back of the refrigerator.
2. Insert the two uncapped bottles into the holes numbered
"1" and "2" in the locating base.
When the sampler controller is configured for two bottles (sec-
tion 3), samples will only be distributed to bottles 1 and 2. If
you place the bottles in positions 3 or 4 the liquid will miss the
bottle.
Note
Bottles caps can be stored between the bottles.
CAUTION
Advertisement
Table of Contents
