Table of Contents
Advertisement
Isco 4700
Refrigerated Sampler
Section 4 Operation
4.1 Start a Sampler
Program
4.1.1 Start Time Delay
In this section...
• Start a Sampler Program
• Pause or Stop a Running Program, page 4-3
• Post Sampling Activities, page 4-3
• View the Log, page 4-3
• Retrieve the Temperature Log, page 4-5
• Remove Sample Bottles, page 4-7
• Grab Samples, page 4-8
• Calibrate Sample Volumes, page 4-8
• Operate the Pump Manually, page 4-9
This section describes how to operate the sampler. These instruc-
tions assume that the sampler has been correctly installed
(section 2), configured, and programmed (section 3).
Before starting a program:
• Verify that the pump tube is in good condition. Refer to
section 5.1.1.
• Place empty bottles in the rack or locating base.
To start the program from the Main Menu screen, press the
green Run Program button.
If a sampler configured for multiple bottles was previously halted
(see section 4.2), the sampler will display a start bottle option
when you press the Run Program Button. This start bottle option
only appears if no programming changes were made after halting
the program.
Using the Number buttons, enter the starting bottle. Then press
the Enter button.
If the program is set for NO DELAY TO START (section 3.5.18),
The sampler immediately begins to operate according to its Con-
figure and Program settings.
ENTER START BOTTLE:
___ (1-max)
4-1
Advertisement
Table of Contents
