Table of Contents
Advertisement
Isco 4700 Refrigerated Sampler
Section 4 Operation
4.3.3 Remove Sample
After the program is complete, the bottles can be removed and
Bottles
prepared for the laboratory. Gain access to the bottles by
releasing the door latch and swinging the door open. The bottles
can then be removed from the rack or locating base. Push the dis-
tributor arm out of the way if needed.
If you are using the 24-bottle rack, you can slide it out to easily
reach the bottles in the back. When sliding the rack out, observe
the rack guides (Figure 4-3). The back two guides run along the
top of the rack to prevent the rack from tipping forward. Do not
pull the rack out beyond these guide pins unless you are securely
holding the rack.
Removed bottles should be capped and labeled according to the
protocol established by your laboratory.
Figure 4-3
Sliding the 24-bottle rack out
4-7
Advertisement
Table of Contents
