IBM Universal Tape Library User Manual page 65

Table 20. Error codes (continued)
Error
code Description
6B The wrong type of tape cartridge is
loaded in the tape drive.
6C The wrong type of cleaning cartridge
is installed.
71 The library controller has failed.
72 The gripper has failed.
73 The displayed screen has failed.
74 The library regulator board has
failed.
76 The library backplane board has
failed.
77 A firmware update has failed.
78 A DRAM failure has occurred.
79 An FPGA failure has occurred.
7A A QSM failure has occurred.
7B The library clock is not operating
correctly.
Recommended action
Load the correct type of tape cartridge and
retry the operation. The library uses LTO3
Ultrium cartridges. For a list of recommended
media for IBM tape drives, see
http://www.ibm.com/pc/support/site.wss/
document.do?lndocid=MIGR-39931.
Load the correct type of cleaning cartridge
and retry the operation. The library uses
LT03 cleaning cartridges. For a list of
recommended media for IBM tape drives,
see http://www.ibm.com/pc/support/site.wss/
document.do?lndocid=MIGR-39931.
Retry the operation. If the problem recurs,
replace the library controller. See "Removing
the library controller" on page 44 for more
information.
Retry the operation. If the problem recurs,
replace the library chassis. See "Removing
the library chassis" on page 43 for more
information.
Replace the library chassis. See "Removing
the library chassis" on page 43 for more
information.
Retry the operation. If the problem recurs,
replace the library chassis. See "Removing
the library chassis" on page 43 for more
information.
Retry the operation. If the problem recurs,
replace the library controller. See "Removing
the library controller" on page 44 for more
information.
Retry the operation. If the problem recurs,
replace the library controller. See "Removing
the library controller" on page 44 for more
information.
Retry the operation. If the problem recurs,
replace the library controller. See "Removing
the library controller" on page 44 for more
information.
Retry the operation. If the problem recurs,
replace the library controller. See "Removing
the library controller" on page 44 for more
information.
Retry the operation. If the problem recurs,
replace the library controller. See "Removing
the library controller" on page 44 for more
information.
Retry the operation. If the problem recurs,
replace the library controller. See "Removing
the library controller" on page 44 for more
information.
Appendix B. Error codes
55