IBM Universal Tape Library User Manual page 66

56
Universal Tape Library User's Guide
Table 20. Error codes (continued)
Error
code Description
7C A camera failure has occurred.
7D Library memory has failed.
7E A library temperature problem has
occurred.
7F The firmware is incompatible with
the library.
80 The MAC address is not correct.
81 A power supply problem has
occurred.
82 A fan problem has occurred.
83 A SCSI failure has occurred.
90 The library firmware update
operation has begun.
91 The tape drive firmware update
operation has begun.
92 The tape drive firmware update
operation has begun.
93 The library backup firmware update
operation has begun.
94 The library firmware update has
been completed successfully.
Recommended action
Retry the operation. If the problem recurs,
replace the library controller. See "Removing
the library controller" on page 44 for more
information. If the problem recurs, replace
the library chassis. See "Removing the
library chassis" on page 43 for more
information.
Retry the operation. If the problem recurs,
replace the library controller. See "Removing
the library controller" on page 44 for more
information.
Retry the operation. If the problem recurs,
replace the library controller. See "Removing
the library controller" on page 44 for more
information. If the problem recurs, replace
the library chassis. See "Removing the
library chassis" on page 43 for more
information.
Update the firmware. See Table 13 on page
32 for more information about updating the
firmware.
Specify the correct MAC address of the host
system. See "Configuring the library" on
page 28 for more information.
Retry the operation. If the problem recurs,
replace the power supply. See "Removing a
power supply" on page 45 for more
information.
Replace the power supply. See "Removing a
power supply" on page 45 for more
information. If the problem recurs, replace
the library chassis. See "Removing the
library chassis" on page 43 for more
information.
Retry the operation. If the problem recurs,
replace the library controller. See "Removing
the library controller" on page 44 for more
information. If the problem recurs, replace
the host bus adapter, using the instructions
that came with your system.
No action is required.
No action is required.
No action is required.
No action is required.
No action is required.