Table of Contents
Advertisement
Chapter 3. Using the menus
Use the menus on the display screen to display information, issue commands, and
test library functions. Use the four control buttons under the display screen to select
menu options and set values. The functions of the buttons change according to the
menu or screen that is displayed.
To display the main screen, press any of the four control buttons under the display
screen.
Table 5 lists the information that is displayed by the menus.
Info menu
Press the Info button to display the Info menu.
Overview information
To display the overview information, complete the following steps:
1. From the Info menu, press the Down (↓) button to select Overview (if it is not
2. Press the Next button to display the following network information:
3. Press the Exit button to return to the Info menu.
Hardware information
To display hardware sensor information, complete the following steps:
1. From the Info menu, press the Down (↓) button to select Hardware, and press
© Copyright IBM Corp. 2007
Table 5. Menu information
Menu
Info
Ops
Setup
Diags
already selected), and press the Enter button. The Firmware Info screen is
displayed.
v IP address
v Network mask
v Gateway
the Enter button. The Hardware info menu is displayed.
Information displayed
v Overview
v Hardware
v Event Logs
v Statistics
v Library Operations
v Find Tape
v Move Tape
v Drive Operations
v Scan Inventory
v Cabinet
v Library
v Security
v Network
v Date and Time
v System-level Test
v Subsystem Test
v Component Tests
17
Advertisement
Table of Contents
