IBM Universal Tape Library User Manual page 39

Table 12. Setup page tasks (continued)
Task Description
Users Use this page to identify library users and to
define e-mail notification. Use the Users page
to specify the following information:
v Full name: The full name of the user
v User name: A unique user name
v Password: The user password
v Verify password: The user password
v Access role: The administrator or operator
v Address: The user address
v Phone: The user phone number
v Fax: The user fax number
v Pager: The user pager number
v E-mail: The user e-mail address.
v Add to Events e-mail list: Add the user to
the e-mail events list
Work with SCSI Use this page to set the SCSI ID or Fibre
IDs or Fibre Channel settings of the library and tape drives.
Channel tape
You must take the library offline to set the
drive
SCSI ID of a tape drive.
configuration
settings
After you set the SCSI ID of the library, you
must restart the library.
Procedure
To add a new user, complete the following steps:
1. From the Status page, click the Setup tab.
The Identification page is displayed.
2. From the Identification page, click the Users
tab. The Users page is displayed.
3. Specify the identification information.
Note: Information that is marked with an asterisk
(*) is required.
4. Click Apply.
To set the SCSI ID, complete the following steps:
1. From the Status page, click the Setup tab.
The Identification page is displayed.
2. From the Identification page, click the
SCSI/Fibre tab. The SCSI/Fibre page is
displayed.
3. If you are setting a tape drive SCSI ID, take
the library offline.
4. Type the SCSI ID of the gripper or tape drive
and click Apply.
5. If you changed a tape drive SCSI ID, bring the
library online.
6. If you changed the gripper SCSI ID, restart the
library.
To set or change the Fibre Channel configuration
settings, complete the following steps:
1. From the Status page, click the Setup tab.
The Identification page is displayed.
2. From the Identification page, click the
SCSI/Fibre tab. The SCSI/Fibre page is
displayed.
3. Specify the Fibre Channel configuration
information:
v Configured speed: Select 1G, 2G, or Auto
negotiate
v Configured topology: Select point-to-point,
arbitrated loop, or Auto negotiate
v Loop ID: Set the loop ID. The loop ID is
required only when the configured topology
is set to arbitrated loop.
4. Click Apply.
Chapter 4. Using the Remote Management utility
29