Starting Up - QRPworks K-Board User Manual

USB Keyboard Port

Starting Up

When the K-Board is powered on:

the three LEDs will indicate the firmware version, in
case you need to know.
o The Red led will flash the number of times of the
o The Yellow led will flash the number of times of
o The Green led flash the number of times of the

example for revision 2.1.3
o The Red LED will flash 2 times, for number 2
o The Yellow LED will flash once, for number 1
o The Green LED will flash 3 times, for number 3
This can also be seen by pressing Alt-Z.

Then the green LED will flash while the K-Board
automatically attempts to connect with the rig via its
serial port. 38400 baud is the required speed.
Note: turn the rig on first before turning the K-Board on.
K-Board User Manual
first number in the version.
the second number in the version.
third number in the version.
rev 1.6 Page 9 of 37