System Reset; Compatibility With Other Products - QRPworks K-Board User Manual

System Reset

If you want to reset the K-Board, press Alt-R. Then press "Y"
to confirm the reset or "N" or ESC to cancel the reset. The
reset is similar to turning the unit off and then on again.
One reason for doing a reset is to re-initiate the
communications to the rig, in case it is not connected.

Compatibility with Other Products

Here's how to use the K-Board with other products.
For the Elecraft products, in general, it is connected as
the last device in the serial (ACC1) connection chain.
 KXPA100 – connect the K-Board to the RS232
(PC) port on the amp.
 KXP500 – connect the K-Board to the RS232 (PC)
port on the amp.
 PX3 – connect the K-Board to the ACC1 (PC) port
on the PX3.
 P3 – connect the K-Board to the DB-9 (PC) port on
the P3.
K-Board User Manual rev 1.6 Page 27 of 37