Voltage Check; Help - QRPworks K-Board User Manual


7023C - sets freq to 7.023 MHz AND mode to CW

28425U - sets freq to 28.425 MHz AND mode to USB
If in CW, RTTY, PSK, and K-Board user prompts are on (Alt-E)
and text decoding is on in the rig, then you will see "FREQ?
displayed on the rig's scrolling display.

Voltage Check

To display the power supply voltage of the K-Board, press Alt-
V. The K-Board voltage will be seen on the rig when text
decode is on and in CW, RTTY, or PSK. Press Esc on the
keyboard to exit this mode.
The K-Board will automatically check the voltage periodically,
and if at or below the low voltage threshold (~7 volts), the Red
LED on the K-Board will flash periodically.

Help

If you forget a command, you can see a list of them with a brief
description on the rig's scrolling display.
With Text decoding on in CW, RTTY, or PSK, press Alt-H. The
commands will be scrolled, separated by a "/". Hit Esc at any
time to stop.
K-Board User Manual rev 1.6 Page 26 of 37