Transmitting Text - QRPworks K-Board User Manual

When the K-Board establishes a connection to a rig, the green
LED will stay on for a few seconds.
- if in CW mode, the rig will send "R" to indicate it is connected.
- if in CW, RTTY, PSK31, or PSK63, and text decoding is on,
you will see "R" on the rig's scrolling display.
If the K-Board does not connect to the rig, the Red LED will
flash for a few seconds and turn off. If you expect a
connection, please see the

Transmitting Text

There are a few ways to send data to the rig:
1. Simply use the paddle connected to the rig. As you
paddle, you will key the rig.
2. Type on the keyboard. The K-Board will send the
character you typed to the rig. As you type, you will key
the rig, and the rig will show what characters have been
sent if text decoding is on.
3. Send a message. You can send one of 20 pre-defined
(by you) messages by pressing F1 through F10 for the
first bank of 10 messages, and Alt-F1 though Alt-F10 for
the second bank of 10 messages. Each message can
be up to 80 characters.
The rig will transmit the text in whatever mode it is set to. In
other words,

if the rig is set to PSK-D, if the rig is set to PSK-D, it will
send PSK31 or PSK63, depending on the VFO A
setting.

if it is set to FSK-D, it will send RTTY.

If it is set to CW, it will send CW
K-Board User Manual
troubleshooting tips
rev 1.6
.
Page 10 of 37