Naming Text Messages - QRPworks K-Board User Manual

Then press a key F1 through F10 or Alt-F1 through Alt-
F10 corresponding to the message you want to create
or edit.

Enter characters from the keyboard. Any previous
message will be erased. Enter the new message
entirely.

When finished, press the F12 key again or Enter to
save the changes and return to the normal mode. The
Yellow LED will go out.
o If in CW mode, you will hear an R and if text
decoding is on, you will see an R on the rig's
scrolling display.
o If in a RTTY or PSK mode, if text decoding is on,
you will see an R on the rig's display.
If you want to cancel the editing of a message, press the ESC
key. The K-Board will return to the normal mode and the Yellow
LED will go out.
When in RTTY or PSK, the rig will remain in transmit mode for
approx. 4 seconds after the last character has been sent. To
have the rig go back to receive immediately after the last
character has been sent, add a vertical bar "|" at the end of the
message (without the quotes). It's especially useful when
contesting or events.
Example: 5NN CO |

Naming Text Messages

The K-Board provides a way to name a message. The name
will then be shown in the message preview (Alt-P) as a handy
reminder.
K-Board User Manual rev 1.6 Page 13 of 37