Sending A Rig Macro - QRPworks K-Board User Manual

of the colon is the rig macro name and is not sent to the rig.
Everything to the right of the colon will be sent to the rig as
commands.
It's advised to keep the names short, as the space for the
characters used are shared with the characters used for
commands. The longer the name, the less room you will have
for commands.
For more information on macros and a complete list of
commands, please see the Elecraft " K3S, K3, KX3 & KX2
programmers Reference" in the Manuals and Downloads
section of the Elecraft website.
Macro Examples: Note the colon. The name is to the left, the
commands are to the right. The period, name and the colon
are not sent to the rig.
.PSK:FA00014070000;MD6;DT3;SWH17;PC005;
.RTTY:FA00014080000;MD6;DT2;SWH17;PC005;

Sending a Rig Macro

To send a stored rig macro, just press F1 to F10 for macros 1-
10 and Alt-F1 to Alt-F10 for macros 11-20. The sequence of
commands will then be sent to the rig.
K-Board User Manual rev 1.6 Page 20 of 37