QRPworks K-Board User Manual page 30

Summary of LED Operation:
The specifics are in the table below, but in general, the LEDs
indicate the following:
Green – a function has been successful or is progressing as
expected
Yellow – user input is required
Red – there is a fault condition
Function
K-Board Startup
Alt-C Enter Call
@ Grab & Go
Message
Alt-N Set Serial
Number
K-Board User Manual
LED
All three flash to
indicate the
firmware
version number
Then, Green
flashing
Green On for a
few seconds
Red flashing for
a few seconds
Yellow flashing
Yellow flashing
Yellow flashing
rev 1.6
Meaning
Red flashed the first
number
Yellow the second number
Green the third number
Trying to connect to rig at
38400 baud
Connected to rig
successfully
Connection to rig failed.
(see Troubleshooting
Waiting for call to be
entered. Enter call followed
by Enter, or hit ESC.
Waiting for call to be
entered. Enter call followed
by same F key, or hit ESC.
Waiting for number to be
entered. Enter number
followed by Enter, or hit
ESC.
Page 30 of 37
Tips)